Sunday, October 31, 2010
Air Filters - Which Gives the Best MPG to Your Car?
Air filters are devices which strain air through a membrane to separate particulates from the air that normally goes into an internal combustion engine. This is to prevent these particulates, such as dust, fiber, pollen and such to contaminate sensitive and hard-to-reach parts of the engine.
Air filters are judged according to two types of attributes: filtration and flow.
Filtration is the ability of the filter to separate particulates from the air. Flow is the ability of the filter to let air move through the filter element with minimal restriction, including the piping that guide air through the air filter and beyond.
Filtration elements are normally composed of paper, cotton, foam, and cloth components.
Paper. This is the most common and cheapest form of filter available. They are efficient, idiot-proof and costs less than other types of filters. The filter is normally a wide, round cylindrical shape about 3 inches in high. Particulates are easily spotted on the pleats of the air filter and can be cleaned off for further use. Paper filters have a shorter use life and are considered easily disposable.
Foam. Foam filters are oil-damp polyurethane elements. These are usually used in rally-type environments with the capacity to trap lots of dust.
Cotton. Oiled-cotton gauze filters are usually found in performance after-market air filters. Employs multiple layers supported by a metal mesh to trap dust and particulates.
Cloth. Cloth are oil-wetted as well and are considered on the same level as cotton-gauze filters. They also employ the same layering as cotton-gauze and are reusable to the point of just washing and re-oiling them.
When air flow is considered, the "plumbing" of the air filter system must be observed. What manufacturers usually attached to air filter systems is a complex set of pipes that flow up and down to slow down air flow somewhat. The purpose of this is to reduce ambient noise, sometimes at the cost of fuel efficiency.
After-market performance components have solved these problems by doing away with the plumbing system entirely and going for a more simplified straight or curved piping system topped with the filter element. This immediately shows better performance over the plumbing-type system but these do not filter out particulates as well.
Some after-market performance filter components usually include cone-shaped filters for cotton and cloth filters, mushroom-shaped filters for foam elements, and some two-stage hybrid filters, which clean out air much more efficiently but at the cost of some air flow.
What else can I do to immediately improve performance?
If all else is held constant, what you can do to improve performance would be to improve the quality of air that is drawn through the air filter. The best value for money-addition to a factory installed or improved-air filtration system would be to add a hydrogen-on-demand (HOD) generator to be drawn in through the air filter.
HOD generators are devices that produce hydrogen and oxygen as electricity passes through an aqueous medium. This gas is more known as "oxyhydrogen" or Brown's Gas or HHO. This gas is generated on-demand only (i.e. when the engine is turned on) so there is no hydrogen stored in its pure form to cause a risk to life and limb.
What does an HOD system do?
Hydrogen when compressed an introduced to an internal combustion engine:
-Releases more energy than ethanol-based mixes, maintaining the overall power of the car
-Completely burns the fuel which gives cleaner emissions
-Raises the octane level of the fuel, preventing knocking, making the engine quieter
-Lowers overall engine temperature slightly
-Requires the engine to use less gas per cycle
Fairly inexpensive. Parts can be sourced from everyday parts found in hardware shops and basic electronics stores. Total cost for a basic unit can range between $70 to over $200 USD.
What's offered by most HOD enterprises are plans for do-it-yourself systems, with offers to build the system for the consumer if they so wish. This way the customer can opt to build it himself or to buy a unit once the concept is understood after obtaining the plans to prevent fraud.
For more information on HOD systems, increasing fuel economies, and support, please visit the url below.
Erwin Chua MCP, MCDST has been involved with cars since he was 22. In his youth he would take the car out for a ride without a license, and never get caught. He has a still-pending Master of Arts in Philosophy from De La Salle University - Manila after he decided to leave the academe in pursuit of the true Way. Currently, he is based in Penang, Malaysia spending his time working out, tinkering and puttering away on his Toyota, practicing the Way, building web sites, and writing articles on technology, health, nutrition, body conditioning, healing and travel.
Article Source: http://EzineArticles.com/?expert=Erwin_Chua